EM-1010: How to Reassemble the Bracket

To re-assemble the bracket, make sure you have all the parts.

Parts

1. Right bracket arm
2. Small left bracket arm
3. Bracket screw
4. Square baseplate with peg
5. Spring with two holes
6. Phillips head screw driver

Assembly Guide

1. Place spring with round indentation facing upwards over the square base plate
2. The peg on the baseplate will go through the springs outer most hole and the inner hole of the base plate will align with that of the spring
3. Place both pieces under the larger right bracket and into the slit with the peg towards the outer portion of the slit
4. Place the smaller left bracket over the right bracket with the peg going through the outer most hole of the small bracket and secure them together with the bracket screw using the Phillips screw driver 
5. To make adjustments to the bracket, loosen the bracket screw slightly to allow the right and left brackets to slide in and out to the proper hoop size then tighten. DO NOT REMOVE THE SCREW OR ELSE BRACKET WILL COME APART.