Your velcro bar is where thread is held until it's ready to be used again. If you need to adjust the velcro bar, follow these steps:
-
Loosen the two screws on the right and left side of the machine's head.
-
To center the velcro bar, move the machine to needle #1 and make sure the hook (located behind the velcro bar) is in the center of the bar. Tighten the two screws to secure the bar in place.
-
Repeat this process on needle #15 to ensure that the velcro bar is properly aligned on both sides of the machine.
Need additional help?
If you are still having issues with the velcro bar or have any other questions, don't hesitate to reach out to us for further assistance. You can contact us by email at service@ricoma.com or visit our support page at www.ricoma.com/US/support for more information.