If your embroidery machine is experiencing consistent thread breaks, follow these steps to identify and fix the issue.
Step 1: Determine If the Issue Affects All Needles or Just a Few
If only one or a few needles are breaking thread, the issue could be related to the thread path or tension:
-
Thread Path: Check that the thread is correctly running through all guides, tensioners, and hooks. If the thread is not in the right path, it can cause unnecessary friction and breakage.
Watch this video for help: How to Thread Your EM-1010-7s Embroidery Machine -
Tension: If the upper or lower tension is too tight, it can cause frequent thread breaks. Loosen the tension knobs by 1 or 2 turns and test again. Also, check that the wheel under the middle knob (marked in orange) spins when you pull the thread from the bottom.
Watch this video for help: Adjusting Thread Tension on Your EM-1010-7s Embroidery Machine
Step 2: Adjust Sensor Sensitivity (If All Needles Are Affected)
If thread breaks occur on all needles and the machine stops after a few seconds, the sensor sensitivity may be too high.
- Click on the 'EMB Param' button.
- Locate the "Thread Broken Sensitivity" parameter. If you don’t see it, select "EMB Param 2" to access more parameters.
- Set the sensitivity to 5 or 7, then test the machine.
- If thread breaks continue, try increasing it to 9 and test again.
Step 3: Test and Monitor
After making these adjustments, run the machine again to see if the thread break issue is resolved. If the problem persists, further troubleshooting may be needed.
If you're still experiencing issues, our support team is here to help! Submit a support ticket here , and we’ll assist you as soon as possible.